If you chose to install your homeit Kit with a CE106 Motorised Lock, then you've made an excellent choice that unites safety and functionality. Due to the fact that this lock has its own integrated electronic controller, the connection to the homeit wireless Box is different from other locking devices.



To connect the CE106 Motorised Lock to the homeit wireless Box, please follow these steps:

  • Preparing the lock connector
    1. Take off the lid with the help of a small PHILLIPS screwdriver.
    2. Locate the ORANGE connection terminal.
    3. Connect 3 wires as shown in the picture.

      • L+: shunt with + (positive)

      • L-: Yellow wire

      • - (negative): Black wire

      • + (positive): Red wire

  • Plug the terminal back into the lock terminal socket.

 



  • Connecting the lock to the homeit wireless Box
    1. Connect 3 wires according to the picture below, to the following terminals:

      • PWR GND: Black wire

      • PWR +12V: Red wire
      • Rel 1 GND: Yellow wire 





Schematic of the connections between the homeit box and the motorized lock:








After the lock is connected as shown above, a LED indicator light will turn on and you will hear an beeping sound. You can now test it and then, if everything is working properly, put the lid back on the lock. The next video shows how the lock works when properly connected:




ATTENTION: If the lock starts beeping and doesn't lock when you close the door, probably the lock and the strike piece are not well aligned. You will have to make adjustments to the fitting, to correct the alignment.


Finally, you just need to configure the Door appropriately. Just access the smartlock configuration app and follow the steps.:

  1. When you reach the following screen:



2. Do not press the START SETUP button! Choose the "If you want to install a different lock, click here to continue" option in the right bottom end of the screen.


3. You will then see the following screen:


4. Press the Motorized lock option and follow the steps.


That's it! Your lock should now be up and running.


Good lock! ;)