This process will reset the BOXv1 current configuration if there is one, leaving BOXv1 as if it was new out of the box ready to be configured.


  1. Open the BOXv1 by removing the plastic enclosure.
  2. Locate the SETUP button on the board. The board has a single blue button about 1mm in diameter near the keypad connector.
  3. Press and hold the button for atleast 5 seconds. Release the button when the LED turns off.
  4. Wait for the blue LED to start blinking fast.
  5. Press and hold the button for atleast 5 seconds or until the LED turns pink. The pink LED will stay ON for around 30 seconds.
  6. Wait for the blue LED to start blinking fast.
  7. Your BOXv1 configuration has been reset and is now in configuration mode. You may close the enclosure and proceed with the normal configuration process.



We are constantly aiming to improve our guides, leave us some feedback down below, thank you!